AC installation and replacement in Conyers, GA means pulling out an aging or failed cooling system and putting in a properly sized, correctly charged, and fully tested unit that can handle what Georgia summers actually deliver. For most homeowners, that means a central split system with a new condenser outside, a new coil on the furnace or air handler inside, and refrigerant lines and electrical connections that meet current code.
Conyers sits about thirty minutes east of Atlanta on I-20, and our crews make that run regularly. The climate here is the same long, humid summer you get across the metro, but the east side of the county tends to catch winter ice storms harder than areas closer to the city. That combination of brutal summer heat and occasional hard freezes puts real wear on equipment over time.
The housing stock here covers a wide range. Older neighborhoods near Olde Town Conyers often have original ductwork from the 1970s and 1980s, and those systems were sized for different equipment than what is available today. Ranch and split-level homes from the same era throughout Rockdale County frequently have ductwork running through unconditioned attic space, which makes proper system sizing even more important. Get the tonnage wrong and the new unit will short-cycle, leave humidity in the air, and wear out faster than it should.
If your current system is struggling to keep up, we can take a look and give you a straight answer about whether repair or replacement makes more sense for your home.
Most central air conditioning systems have a general industry lifespan in the range of fifteen to twenty years, though actual performance depends heavily on how well the equipment was maintained and how hard it had to work. If your system is past the twelve-to-fifteen-year mark, replacement is worth a serious look even before something fails completely.
Repeated repairs are a clear signal. Capacitors, contactors, and blower motors wear out, and one or two service calls over the life of a system is normal. But when you are calling for repairs every summer, the math shifts. At some point you are spending money on a system that is still going to need replacing.
Homes in the older sections near Olde Town Conyers and through the ranch subdivisions built in the 1970s and 1980s often still have R-22 refrigerant systems. R-22 is no longer manufactured, which makes recharging those systems expensive and harder to justify. A refrigerant leak on an R-22 unit is usually the tipping point.
High summer electric bills are another indicator. Conyers summers are long and humid, and an aging system that is losing efficiency will run longer and harder to hit the same thermostat setting it used to reach easily. If your bills have climbed noticeably over the past few years without a change in how you use the home, the system efficiency is likely the reason.
Finally, if you have added square footage or converted a space, the existing system may simply be undersized for what it is now being asked to cool. A system that was right for the original footprint will struggle with an addition, and no amount of maintenance will fix a sizing problem.
Every replacement job starts with a load calculation. We measure the home, account for insulation levels, window area, ceiling height, and orientation, and use that to determine the correct system size. Skipping this step and just matching the old tonnage is a common shortcut that leads to short-cycling, poor humidity control, and premature equipment failure. We do not skip it.
Once we know the right size, we walk you through equipment options and efficiency ratings. Higher SEER ratings reduce operating costs over time, and the right choice depends on how long you plan to stay in the home and what your monthly bills currently look like. We explain the tradeoffs plainly so you can make the call.
On installation day, the crew removes the old condenser and coil and disposes of the equipment properly, including recovering any remaining refrigerant. The new condenser goes in outside, the new coil is set on the air handler or furnace inside, and we run or inspect the refrigerant lines and make sure the electrical connections and disconnect are correct and up to code. We also check the condensate drain line and make sure it is clear before startup.
After everything is connected, we start the system, verify the refrigerant charge, check airflow at the registers, and confirm the thermostat is communicating correctly with the new equipment.
What drives the cost and timeline of a replacement job includes the system size and efficiency rating you choose, the condition of your existing ductwork, whether the electrical panel or disconnect needs an upgrade, and the work involved in removing the old equipment. Your estimate will account for all of it so there are no surprises on the day of the job.
Whether you are still weighing your options or ready to get on the schedule, we have resources that can help you take the next step.
If you want a broader look at the heating and cooling services we provide in the area, our Conyers HVAC service page covers everything we handle for homeowners and commercial clients in Rockdale County, from maintenance and repairs to full system replacements.
If you are researching the replacement process itself before committing to a conversation, our AC installation and replacement service page walks through how the job works, what to expect, and what factors shape the scope of a project.
And if your system has not failed completely but you are dealing with warm rooms, weak airflow, or a unit that runs constantly without keeping up, it is worth finding out whether a repair might extend the life of what you have. Our AC repair page for Conyers covers the most common problems we see and how we approach diagnosing them.
Homes along the Salem Road corridor with newer construction and homes closer to Honey Creek with older equipment present very different situations, and we are used to working through both. Give us a call or request your estimate and we will figure out what makes sense for your home specifically.
+
