An electrical panel upgrade in Newnan, GA replaces an outdated or undersized breaker panel with a new service panel sized to handle your home’s actual load, brought up to current Coweta County code and signed off by a licensed inspector.
If your panel is full, your breakers trip under everyday use, or you are adding a heat pump or EV charger, an upgrade is often the right fix. Newnan homes range from historic Victorian and antebellum houses near downtown to builder-grade subdivisions and newer master-planned communities like SummerGrove, and the electrical demands inside those homes vary just as widely. One house may need a larger service; another may need a panel swap because the existing equipment is a known safety problem. The answer depends on what is inside your walls and what you are asking the system to do.
All Purpose Heating & Air Conditioning has been doing this work for more than 35 years. Our crews are in Coweta County every week, so scheduling is straightforward and we know the local permit and inspection process well.
If you are not sure whether your panel needs to be replaced or just serviced, give us a call. We will take a look and give you a straight answer.
Some warning signs are obvious. Others are easy to ignore until something goes wrong. Here is what we see most often in Newnan homes.
Homes in newer subdivisions like Avery Park or Newnan Crossing sometimes have builder-grade panels that were sized for the original load. Once a homeowner adds a home office, a workshop in the detached garage, or a pool, that original panel is often the first thing that needs attention. West Georgia summers push air conditioning loads hard for months at a time, and a panel that was marginal in spring can become a real problem by July.
A panel upgrade is not just swapping one box for another. Done correctly, it follows a specific sequence, and each step matters.
Load calculation. Before we pull a permit, we calculate the actual electrical load your home places on the service. This tells us what amperage you need and whether the service entrance and meter base have to be replaced along with the panel. Skipping this step leads to panels that are still undersized after the upgrade.
Permit and utility coordination. Coweta County requires a permit for panel replacements, and Georgia Power has to disconnect and reconnect service at the meter. We handle both. Permit and utility fees are part of the total cost of the job, and the timeline depends in part on how quickly the utility can schedule their side of the work.
Panel and breaker replacement. We remove the old panel and install the new one, including AFCI and GFCI breakers where current code requires them. Older homes near downtown Newnan sometimes have aluminum branch-circuit wiring, which requires specific breakers and terminations. We account for that during the installation.
Grounding and bonding. A new panel has to be properly grounded and bonded. If the existing grounding electrode system does not meet current code, we bring it up to standard as part of the job. This affects both cost and timeline.
Inspection. A Coweta County inspector signs off on the completed work before Georgia Power reconnects service. That inspection is not a formality. It is the confirmation that the work was done correctly.
Cost varies based on amperage, whether the service entrance and meter base need replacement, permit and utility fees, and any grounding upgrades required. Request your estimate and we will give you a clear number for your specific situation.
A panel upgrade solves a lot of problems, but sometimes the panel is fine and the issue is in the circuits themselves. And sometimes both need attention at the same time. Knowing the difference matters before any work starts.
If you want to understand the full scope of what we do for homeowners in this area, our electrical services page for Newnan, GA covers everything from panel work to new circuits and troubleshooting. It is a good starting point if you are not sure what you need.
For homeowners who already know they need a panel replaced and want to go deeper on what the job involves, our electrical panel upgrade service page walks through the process in more detail, including what to expect on the day of the job.
If your panel is fine but specific circuits are giving you trouble, or if an older home has wiring that needs to be brought up to code, our page on rewiring circuits in Newnan covers that work specifically. Detached garages, finished basements, and home additions are common reasons homeowners in Coweta County end up needing circuit-level work alongside or instead of a full panel replacement.
Whatever the starting point, give us a call or request your estimate. We will look at what you have and tell you exactly what the job requires.
+
